Quick Answer: How do you prepare a new dive mask?

How do you clean a new dive mask for the first time?

Use a small blob of regular white toothpaste (not gel), get comfy and rub that stuff around and around your mask. Take a short break, then get rubbing again. Put a good movie on and keep going, yes it’s tedious! You could use a cloth, or an old toothbrush too.

What do you do with a new snorkel mask?

Take a thimble-sized amount of common white non-gritty, non-minty toothpaste and rub it on both sides of the lens while the lens is dry. Avoid gel toothpastes. With clean fingers, give it a good circular rubbing motion and cover the entire lens on both sides. Rinse the lens with clean water to wash away the toothpaste.

How do you keep a dive mask from fogging up?

If your mask fogs up while out snorkeling, simply tread water, spit in your mask a couple times, rub it around, give it a really quick rinse and then put your mask back on. Be sure to get as much water out of the mask as you can before putting your mask back on.

Does toothpaste work as anti fog?

Like the baby shampoo, a coat of toothpaste can prevent condensation from forming on the lens of your goggles. However, it is not advised to use abrasive toothpaste as that might cause scratches on your goggle lenses; and just using a small amount is enough.

THIS IS INTERESTING:  Can your animals die in raft?

How do you maintain a dive mask?

How to Care for Your Diving Mask

  1. Store your dive mask in a cool, dry place.
  2. Clean your dive mask regularly and thoroughly.
  3. Keep your lens clear with an anti-fog solution.
  4. Don’t discard your mask immediately after diving.

How do you use a 500 psi mask?

Easy to use just apply a small amount to the dry interior lens surface and rub in firmly using your fingers, then just rinse in fresh water to clean. 500PSI Mask Scrub comes in a convenient 2 fl. oz. (59 ml) applicator.

How do you clean a scuba mask with toothpaste?

How to Pre-Treat a New Dive Mask

  1. To remove the film, use a slightly abrasive agent like toothpaste. …
  2. Take a thimble-sized amount of toothpaste and rub it on both sides of the DRY lenses. …
  3. Rinse the lens while rubbing away the toothpaste. …
  4. Once the toothpaste is rinsed away, DRY the lens with a clean towel or rag.

How do you disinfect a snorkel and mask?

Deep cleaning:

  1. Dilute a tablespoon of bleach in a bucket of warm water.
  2. Soak the snorkel in the bleach solution for up to 30 minutes.
  3. Rinse thoroughly under running water.
  4. Allow the snorkel to air dry.