Question: How do you fix a scratch on a jet ski?

How much does it cost to repair fiberglass on a jet ski?

The cost of fiberglass and gelcoat repair can vary depending on the level of damage on the surface. The usual repair cost can vary from $75 to $110, per hour.

Can you fix a scratch in fiberglass?

Apply a small amount of polishing compound to a soft cloth if the petroleum jelly fails to remove the scratch. Rub the compound into the scratch in a circular motion. Rub your finger over the scratch to assess your progress. Repeat this process several times, or until the scratch disappears.

How much does it cost to fix a jet ski?

Servicing a jet ski usually breaks down into two parts; the annual service, and the winterization, which are often done at the same time. These yearly jet ski services cost around $300-$600 depending on the model and the location of your dealership.

How much does it cost to fix a jetski?

If you already have the engine and are just looking for a complete rebuild kit, you may only need to spend $300-$400. However, if you’re looking at rebuilding with individual parts, you may run it up to around $500 or more. Any which way you slice it, rebuilding your PWC engine yourself will save you a ton of money.

THIS IS INTERESTING:  Question: Where should a dive knife be placed?

Can gelcoat be repaired?

You can usually fix gelcoat repairs yourself. It takes a bit of patience, but do it right and few will notice. … Also, deep gouges may need structural fiberglass work or filler before you repair the gelcoat. On horizontal surfaces, liquid gelcoat works, but for vertical surfaces, a paste is easier to apply.

How do you get light scratches out of gelcoat?

Wet-Sanding Scratched Gelcoat

Often very minor scratches and scrapes can be wet-sanded away. Try using 400-grit wet-sanding sandpaper, followed by 600-grit. Always use a sanding block so you don’t over-sand one particular spot, and use a gentle, circular motion. If the scuff or scratch disappears, great.

How do I fix a scratch in my bathtub?

Scratches and dulling can be removed with a liquid polisher such as Gel-Gloss or metal polish. Deep scratches or burns can be removed by use of very fine sandpaper and then finishing with a liquid polish. Using a damp sponge, wash the area with warm water and dishwashing liquid. Rinse thoroughly with warm water.

How do I protect my jet ski hull?

Using XPS Marine Spray Wax with Polymer acts as a sealant to protect your Sea-Doo watercraft surface and prevent algae, rust and other water contaminants from finding a home on your hull and deck. You’ll keep those attention-grabbing looks for many rides to come.